Download E20-331 Exam iEngine Demo
1. A UNIX server has 4 HBAs. Each HBA is zoned to a different FA port on a DMX1000. Each HBA has access to the same 20 Symmetrix Devices. PowerPath has been installed and configured on the UNIX Server.
Applications A & B have each been assigned 10 devices. Performance is extremely important for Application A, while availability is critical for both applications.
Which PowerPath configuration will meet the requirements?
A.Set the load balacing policy for all devices for both applications to Least I/O
B.Set the load balancing policy of all paths of Application B to Symmetrix Optimization
C.Set the mode for 2 of the paths of Application B to Standby and the other 2 to Active
D.Set the mode for all paths of Application B to Standby and all paths of Applicaton A to Active
Answer: C
2. Which two TimeFinder/Clone actions are initiated when issuing a symclone establish command?
A.Activate and Restore
B.Create and Activate
C.Create and Terminate
D.Re-create and Terminate
Answer: B
3. In order for an R2 device to act as a control device for Open Replicator hot push, what is the valid state for a synchronous R1 and R2 pair?
A.Consistent
B.Failed Over
C.Synchronized
D.SyncInProgress
Answer: B
4. In a Single Hop SRDF/AR setup the following options have been set:
The symreplicate session was started at time 0. The actual cycle time was 450 seconds. How many seconds after the start of the first cycle will the next cycle start?
A.300
B.450
C.600
D.900
Answer: C
5. Click on the Exhibit button.
A disaster has occurred at the Workload Site of a SRDF/Star triangle. What is the first SRDF/Star action that must be performed to allow production to start at the Synchronous Target Site?
A.connect
B.enable
C.protect
D.switch
Answer: D
6. Click on the Exhibit button.
Which Open Replicator operations can be performed between the DMX and third-party array with the architecture displayed?
A.Cold Push and Cold Pull only
B.Cold Push and Hot Push only
C.Cold Push, Cold Pull, Hot Push and Hot Pull
D.Hot Push and Hot Pull only
Answer: A
7. In which operating system will disk numbering be changed with a dynamic 'createpair' operation?
A.AIX
B.HP-UX
C.Linux
D.Windows
Answer: A
8. Click on the Exhibit button.
<Missing>
A disaster at the source Symmetrix site caused an SRDF/A Multi-session consistency group (MSC group) to stop propagating host writes to the target site. At the time of the disaster one of the target arrays had a complete Receive Delta set and the other one had an incomplete Receive Delta set.
Which action must be performed on the target site data to ensure dependent write consistency?
A.Consistent split
B.Database recovery
C.Enable consistency
D.MSC cleanup
Answer: D
The hot exam:1D0-460 exam and HP0-381 exam and HP0-045 exam and 1Y0-310.
- 0 ratings
